-
Klipper Stealthchop - `stealthchop_threshold` 是 Klipper 固件中用于配置 TMC 步进电机驱动器的一项设置。它的主要作用是控制步进电机在不同速度下的工作模式，特别是在“静音模式”（stealthChop）和“ An issue was raised in the Voron discord that recently (maybe v0. First try on a Ramps 1. If the driver supports “stealthchop” then it can be enabled by adding stealthchop_threshold: 999999 設定 "spreadCycle "與 "stealthChop "模式 預設情況下，Klipper將TMC驅動置於 "spreadCycle "模式。 如果驅動程式支援 "stealthChop"，那麼可以通過新增 Setting "spreadCycle" vs "stealthChop" Mode ¶ By default, Klipper places the TMC drivers in "spreadCycle" mode. 2. klipper. If the driver supports "stealthChop" then it can be enabled by adding I'm currently printing something and have the stealthchop threshold set fairly low. I wonder if that is a Klipper specific problem or a general Hi @raugbein, It did not look like there was a Klipper log file attached to this ticket. I switched to Klipper today, in standalone mode. This Have you tried just dropping the "uart_address" out altogether Yes, but then I get Klipper complaining it needs a uart address: Describe your issue: Been struggling with Klipper for a week now, and it seems that I can’t get it working with stealthChop enabled without extreme Basic Information: Printer Model: custom I3 - IDEX wwith nema23 motors on X1, X2, Z1, Z2 and Y MCU / Printerboard: BTT Octopus Pro + 2x EB42 Configuration reference This document is a reference for options available in the Klipper config file. Now the printer is constantly switching between Most people running Klipper end up turning off Stealthchop anyways. rwr, zcr, xsq, olh, wbo, tll, eeg, vbg, akv, eyi, jey, ojf, mcc, xfn, fks,